DC CONNECTOR

A DC Jack Male Power Connector with a wire and a 5.5×2.1mm specification is a commonly used connector for low-voltage DC power applications. Here are some details and uses of this type of connector:

Features:

1. Connector Type: Male DC power plug.
2. Dimension:
   • Outer Diameter (OD): 5.5mm
   • Inner Diameter (ID): 2.1mm
3. Wire Length: Typically ranges from 20cm to 1m, depending on the supplier.
4. Polarity: Usually configured as:
   • Positive (+) center pin.
   • Negative (−) outer sleeve. (Always confirm polarity before use.)
5. Cable Material: Flexible, often made with PVC or similar insulating materials.
6. Current Rating: Usually rated for 1A to 5A, depending on wire gauge and connector quality.
7. Voltage Rating: Generally used for DC voltages up to 24V, though specific ratings may vary.

Applications:

• Consumer Electronics: Commonly used to power devices like routers, cameras, and small appliances.
• DIY Projects: Ideal for prototyping and custom electronic setups.
• LED Strips and Modules: Often used for powering LED lighting solutions.
• Small DC Motors: Used in robotics and other motorized applications.

Installation Notes:

• Ensure that the power source matches the voltage and current requirements of your device.
• Double-check the polarity before connecting to avoid damage.
• Use heat shrink tubing or electrical tape for additional insulation if the connector comes with exposed wire terminals.

Would you like further details on how to install or where to purchase this connector?